Craftsman 113.298761 - Manual (Page 14)

assembly
2. insert two 3/4 inch screws though two fiat washers
then through holes in switch holes in switch.
3. Insert screws through holes eight and ten in front
fence guide bar as illustrated.
4. Install two bckwasher and nuts. Tighten nuts.
JAM NUT
5/1S-18
INSTALLING RIGHT FRONT RIP FENCE
GUIDE BAR
1. From among the loose parts, find the following hard­
ware:
*2 Hex Head Screws, 5/16-18 x 1-3/4
*1 Hex Head Saews, 5/16-18 x 3/4
*4 Lockwashers, 5/16 External Type
*4 Hex Nuts 5/16-18
‘3 Spacers, 3/4 diameter x 1/2 long
*1 Hex Head Screw 5/16-18 X 1-1/4
*2 Flat Washers 5/8 x 1/16
1 Bracket
Items marked with an asterik (*) are shown actual size.
5/16-18 X 1-1/4 IN
HEX HEAD SCREW 5/16 IN EXTERNAL
LOCK WASHER
f6l
lUJ
5/16 IN
HEXNLTT
M" £^i 6 -18^X 1 3/4 IN.
HEX HD. SCREW 5/16-18 X 3/4 IN
HEX HEAD SCREW
5/8 X 1/16 IN WASHER 3/4 IN. DIA. X1/2 IN.
SPACER
BRACKET
2. Put the bracket against the right edge of the rght
extension so the bracket is lined up with the FIRST
hole near the front of the extension. Insert a 3/4 long
screw through a flat washer, through top hole in the
bracket^ and through the FIRST hole in the extensbn.
Instailalockwasherand nuton the screw. Tightenthe
nut only slightly. HEX NUT
EXTERNAL
LOCKWASHER
BRACKET
WASHER
HEX HEAD
ef'Rpw
5/16-18 X 3/4 IN
3. Lay Guide Bars on saw table.
NOTE; The various holes in the Bar allow them to be
positioned on the saw and also makes them adapt­
able to other models.
...
4. inserta 1 -3/4 inch long screw throug h the THIRD hole
from LEFT in the Front Bar. Insert another 1-3/4 inch
long screw through the SEVENTH hole in Bar.
5. Place spacers on screws.
rXH HOLE
3RD HOLE
LEFT SIDE OF
FRONT GUIDE BAR
(GUIDE BAR IS TO BE
TURNED END FOR END
AFTER SCREWS ARE
INSTALLED)
HEX HEAD
SCREW
S/1S-181Í1-3/4 IN.