Rip fence alignment adjustment, Assembly – Craftsman 113.298761 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
assembly
If the Fence does not slide easily along the Bars, the
pressure of the spring can be REDUCED.
1. Loosen the screvws.
2. Move spring slightly toward rear of Fence. Tighten
screws.
WARMING: To avoid injury from jamsorkldcbacks,
be sure to push properly adjusted Lock Lever all the
way down until the lever rests on the stop beRsre
using
the
Rip
Fence.
RIP FENCE LOCK LEVER ADJUSTMENT
The Rip Pent» Lock Lever, when locked down, should
hold the Rftj Fence securely, it should not be difficult to
push down and lock.
If Lock Lever does not lock fence securely:
1. Raise Lock Lever.
2. Tighten the adjusting nut using a smalt screwdriver
until the lever, when bcked, hotels the Rip Fence
seoirely.
If Lock Lever is difficult to push down:
1. Raise Lock Lever.
2. Loosen the adjusting niit using a small screwdriver
Fence securely.
RiP FENCE ALIGNMENT ADJUSTMENT
1 The Rip Fence must be
parallel
with the
sawblade and Miter Gauge Grooves. Move Fence
until it is along side of Groove. DO NOT LOCK IT. It
should be parallel to Groove. If it is not;
A. Loosen the two Hex Hd. Screws.
B. Hold Fence head tightly against Bar. Move end of
Fence so that it is parallel with Groove. ..................
C. Alternately tighten the screws.
D. Recheck alignment.
E. Repeat steps as needed.
WARNING: A misaligned fence can cause kick
backs and jams. To avoid injury, follow these In-
structlons until the fence is properly aligned.
18