Craftsman 836.27233 - Manual (Page 6)

3-Prong Plug
Figure B
Grounding Lug
Grounding Prong
Properfy Grounded
3-Prong Outlet Adapter
Make Sure This
is Connected to a
Known Ground
2-Prong
Receptacle
FIGURE (A) Shows a 3-wire electrical
plug and outlet that has a grounding
conductor. If a properly grounded outlet
is not available, an adapter
(FIGURE B)
can be used to temporarily connect
this plug to a 2-contact ungrounded
outlet. The adapter
(FIGURE B) has a
rigid lug extending from it that MUST
be connected to a permanent earth
ground, such as a properly grounded
outlet box. The Canadian Electrical
Code prohibits the use of adapters.
USE ONLY 3-WIRE EXTENSION
CORDS THAT HAVE 3-PRONG
GROUNDING PLUGS AND 3-POLE
RECEPTACLES THAT ACCEPT THE
TOOL’S PLUG.
A WARNING
If you have any doubts as to whether
the tool is properly grounded or if the
grounding instructions are unclear,
check with a qualified electrician or
service technician.When using a
grounded tool around other ungrounded
devices, be sure that the ungrounded
devices are in good condition. An
ungrounded device can function, yet
have internal electrical problems that
could cause a hazard when brought in
contact with a grounded tool.
THE ADAPTER SHOULD ONLY BE USED
until a properly grounded outlet can
be installed by a qualified electrician.
ACCESSORIES AND ATTACHMENTS
AVAILABLE ACCESSORIES
Visit your Sears Hardware Department
or see the Craftsman Power and
Handtool Catalog for the following
brad nails;
Sears Stock No.
Inch . mm.
27218 3/8 10
27216 3/4 20
27215 1 25
27214 1-3/16 30
These brad nails can be used for;
Cabinet making
Interior decorations
Wood furniture building/repair
Display assembly
Picture frames
Door & window trim
NOTE: Use only brad nails
recommended for this nailer. Using
other sizes may be dangerous.
Sears may recommend other
accessories not listed in this manual.
Do not use accessories unless you
have completely read the instruction
manual for that accessory.
AWARNING
Do not attempt to modify this tool or
create accessories not recommended
for use with this tool. Any such
alteration or modification is misuse
and could result in a hazardous
condition leading to possible serious
personal injury.
Page 6