Transporting coolscan, Connecting ac power to the ls-10e, Connecting ac power to the ls-1oe – Nikon LS-10 Installation Guide for Windows User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up Cools<an
Chapter 2
8
.
Avoid places with extremely hot or cold temperatures (below 10 degrees Celsius
or above 35 degrees Celsius).
9. Avoid placing Coolscan near heat sources.
10. Avoid any physical shocks to the scanner. Do not store the unit where it will be
subject to vibration.
11. Avoid placing Coolscan too close to other peripherals, and make sure there is
sufficient air circulation on all sides of the scanner.
Transporting Coolscan
The following guidelines and precautions should be adhered to when transporting
your Coolscan;
1. Always use the original packaging materials.
2. If the original packaging materials are unavailable, use appropriate packaging
materials for precision instruments. If you are shipping your Coolscan back to
Nikon, Nikon will not be responsible for damages incurred due to improper packag
ing.
3. The focus wheel must be turned all the way downward to the end of its travel
before shipping.
4. Pay special attention to the air or courier service to ensure that they can properly
handle this precision instrument.
If you are installing an LS-10, please proceed to the section “General Safety
Precautions.”
Connecting AC Power to the LS-10E
The scanner’s AC power cord is a standard three-wire grounding plug. This plug
will fit only a grounded AC outlet. Intended to be a safety feature, the grounding connec
tor should not be defeated. Additionally, an electronic surge protector is highly recom
mended.
Page 10
Nikon
Coolscan Installation Guide for Windows