Canon IXUS Z70 - Manual (Page 53)

Changing the Print Quantity After Taking a Shot
— -
Tm#
Oai#
-p -ri- i Off®
' i""o L
1^13;
=L_ i
1
Press the ^ button CL and
press the Select button for
two seconds, or ionger ®.
• Use the push-button
projection on the strap to
push the button
•♦“P-0” (no print) blinks in the
LCD panel.
-> -n- O
jp
S—
CZZ!)
TIB#
It
Press the S button until
the number of prints you
want to set for the shot
appears In the LCD panel.
^The print quantity display
changes as follows: P-1,
P-2 P-9, P-0, P-1
_____________ Select
Press the Set button.
^The film Is rewound one
frame and the print quantity
setting is adjusted.
• The setting is complete and
the display changes to the
date and time. g
■ if the camera is turned off before either of the film
quantity setting procedures Is completed, the setting
will revert to the previous setting.
• You cannot use the print quantity setting when “.....” is
displayed on the LCD panel. Make sure that the date
and time have been set before setting the print quantity.
• Press the @ button once to advance the print
quantity by one, keep the button pressed to advance
the value continuously.
■ Not all print shops can process the print quantity
setting when the film is developed and printed. j
_____________ ..._______________ _____________ j
0-53