Canon E 430 - Manual (Page 17)

Charging Battery Pack nsra
Use the CA-100 Compact Power Adapter or the
optional CB-110 Car Battery Adapter to charge
battery pack.
Connect the battery pack to the CA-100 (or
CB-110) as shown and plug into mains outlet
(or car cigarette lighter socket).
When the OPERATE indicator (green) is
glowing steadily and the CHARGE indicator
(red) is blinking, charging has begun. When the
battery pack is fully charged, the CHARGE
indicator will glow steadily. Disconnect the
battery pack from CA-100 (or CB-110).
O
Battery Pack
• CA-100 Compact Power Adapter or
CB-110 Car Battery Adapter
O Charge Indicator
•
Operate Indicator
• Always disconnect the DC-100 DC Coupler
from the CA-100 (or CB-110) before charging
the battery pack.
• The charging time for one battery pack is
shown in the table on the next page.
Charging time will vary according to ambient
temperature and remaining charge in battery.
• When charging a brand-new battery pack or
one that has not been used for three months
or more, charge up completely (until the
CHARGE indicator lights). Then disconnect
and reconnect battery pack to charge once
again.
• It is possible to charge battery pack in an
ambient temperature range of 0°C-40°C, but
for best results, charge between 10°C-30°C.
Use of battery pack in extremely high
temperatures (above 40°C) may activate
safety circuit, making operation impossible.
• When you don’t expect to use battery pack for
a long time (three months or more), store it
in a discharged condition. Storing the
battery pack in a charged condition will
shorten its operating life.
• Immediately after use the battery pack will be
hot, and it is best not to recharge it at this
time. Make sure the battery pack has cooled
off before recharging it.
• The optional MC-100 Multi-battery Charger
can also be used.
For further information, see the adapter or
charger instruction manual.
ao
m ■ n
O
3J
m
c
CO
z
o
15