Acolyte RibbonLyte in Recessed Channel - Manual (Page 3)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
I N S TA L L AT I O N - - S T E P S 1 - 4
1
3
2
4
Rout or cut a slot in your desired installation
material that fits the width and depth of
your channel (A).
Use a counter-sink drill bit and drill through
the channel into the mounting material.
Insert the channel (A) into the cut-out area
so that the flanges on the side sit flush
against the mounting material. If necessary,
use tape to temporarily hold the channel in
place.
Screw the channel into the material with the
appropriate sized screws (B).
PA G E 2
(A)
(A)
(B)