Acolyte RibbonLyte without Channel - Manual (Page 5)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
I N S TA L L A - - S T E P S 5 - 8
5
7
6
8
Apply the RibbonLyte (E) by placing one
end of the strip at the end of the double-
sided tape (B) inside the channel then slide
your finger along the RibbonLyte (E) to
make sure there is firm contact and that the
tape adheres well.
Drill pilot holes at the center of each mark
you made.
Every 12 inches place a silicone pad (C) over
the RibbonLyte (E) and use a pencil to mark
where each pilot hole will be drilled. DO
NOT place the pad above an LED. Place it
as close to 12 inches as possible, while not
touching any LEDs.
Tighten the screws (D) through the silicone
pads (C) until all of the pads are secure and
the RibbonLyte (E) is held tightly in place.
(E)
(B)
(E)
(E)
(C)
(C)
(D)
PA G E 4