Acolyte RibbonLyte without Channel - Manual (Page 9)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
I N S TA L L B - - S T E P S 9 - 1 1
9
11
10
Apply the RibbonLyte (E) by placing one
end of the strip at the end of the double-
sided tape, then slide your finger along the
RibbonLyte (E) to make sure there is firm
contact and that the tape adheres well. The
RibbonLyte (E) should go directly over the
top of the zip tie pads (C).
Snip the tail off the zip tie (D) with scissors
or wire snips.
Wrap the zip tie (D) around the RibbonLyte
(E) and slide the tail of the tie through the
other end until it holds its position and has a
snug fit.
PA G E 8