Acolyte Waterproof RibbonLyte without Channel - Manual (Page 3)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
A - M O U N T W AT E R P R O O F R I B B O N LY T E W I T H S I L I C O N E PA D S
1
2
Clean the mountain surface free of dust
and debris using a wet cloth. For metal
mounting surfaces use rubbing alcohol (A)
to wipe clean.
Remove the backing from the RibbonLyte
(D) that you are going to be mounting.
3
4
Apply the RibbonLyte (D) by placing one
end of the strip at the end of run, then slide
your finger along the RibbonLyte (D) to
make sure there is firm contact and that the
tape adheres well.
Every 12 inches place a silicone pad (B) over
the RibbonLyte (D) and use a pencil to mark
where each pilot hole will be drilled. DO
NOT place the pad above an LED. Place it
as close to 12 inches as possible, while not
touching any LEDs.
(A)
(D)
(D)
(D)
(B)
PA G E 2