Acolyte Waterproof RibbonLyte without Channel - Manual (Page 7)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
I N S TA L L B - - S T E P S 5 - 8
5 6
Screw the zip tie pad (B) into place with a
size 8 counter sunk flat head screw.
Size 8
Slide zip ties (C) through the openings
in each of the zip tie pads (B) but do not
connect the ends of the zip ties.
8
Apply the RibbonLyte (D) by placing one
end of the strip at the end of the run, then
slide your finger along the RibbonLyte (d)
to make sure there is firm contact and that
the tape adheres well. The RibbonLyte (D)
should go directly over the top of the zip tie
pads (B).
PA G E 6
7
Remove the backing from the RibbonLyte
(D) that you are going to be applying.
(D)