AItech ProA/V Media Extender - Wireless HDMI - Manual (Page 10)

9
C. Remote Controller Unit (RCU) Instruction
Note :
1.
Press Power key to transmitter,
transmitter will enter Listen mode and
Loop-thru. display always on. Press Power
key to receiver, both transmitter and
receiver will enter Standby mode and
Loop-thru. display off.
2. The “Standby” mode uses consumes 90%
less of the power. User have to press both
power key on transmitter and receiver to
resume.
3.
Enable the “Wide” mode for longer
distance transmission; It’s suitable for
multi-room audio/video transmission or
transmission between different floors.
Button Function Description Operation
POWER
Press to turn the
Transmitter/Receiver
on/off.
See the below Note 1 &
2. Press it point at receiver
to enter “Standby” mode
with Loop-thru; Press it
point at transmitter to
enter “Standby” mode
without Loop-thru.
INFO.
Press to display between
“Channel”, “Source”,
“Resolution”, “WIDE
mode” and “ Signal
Quality”.
Press once to display the
current
status. Press
again to exit OSD.
SOURCE
Press this button to
switch between
audio/video sources
connected to the
TRANSMITTER.
Press to go to the next
input source. Users can
see the current setting
on the OSD.
CHANNEL
Press this button to
change between wireless
channels manually if the
user experiences video
noise.
Press once to display the
current “Channel” status.
Press again within 5
seconds to switch to
another channel, and the
channel number will be
displayed on the OSD.
WIDE
Press this button to boost
video
transmission
distance wirelessly. The
default setting is to
disable. See the below
Note 3.
Press this button to
enable and disable Wide
mode. Press again within
5 seconds to enable
WIDE mode, and the
status will be displayed
on the OSD.
Remote