AItech ProA/V Media Extender - Wireless HDMI - Manual (Page 21)

20
(8) If all operation is normal, the POWER LED and SOURCE LED will glow in solid blue. Please refer
to the next form containing detailed LED description :
Note:
A. Make sure your High-Definition audio/video devices connected to the TRANSMITTER has
already been powered on.
B. Warming-up or source switching time should take approximately 20~30 seconds if the
operation is in normal condition.
(9) TRANSMITTER/RECEIVER Status Indicator LED Light and OSD :
Status indicator LED light on the front display the following messages:
Power LED Source LED Mode Status Description OSD Display
Static Purple
on TX
Static Red on
RX
Static Blue
on TX
Off on RX
Listen
To lower power
consumption;
“Loop through” display
always on. Please refer Section
2.2, paragraph C &
D for detailed
description.
Static Red Off Standby
For very lower power
saving (EuP) used.
Please refer Section
2.2, paragraph C &
D for detailed
description.
Blinking Blue Blinking
Initial
Boot up
During system boot up,
it required 1min or more
for DFS channels scan
and CAC waiting.
Searching available
channels…
Blinking Blue Blinking
Booting
and Linking
RF linking
Searching available
channels…
Blinking Blue Blinking
Booting
and Linking
Verifying signal. Verifying
Blinking
3 times /sec.
(Quickly)
No input detected from
selected source.
No Signal
Blinking
1 time / sec.
(Slowly)
Video frame rate or
resolution cannot be
recognized. (Not
supported or out of
range.)
No Supported
Format.
Static Blue
Static Blue
Linked
Video frame rate or
resolution is recognized.
Transmission is available
with stable RF signal.