Alumax 750D - Manual (Page 2)

EPH-N00-06060
12-10-04
Page 2 of 8
LIMITED WARRANTY AND REMEDY
A LUMAX B ATH E NCLOSURES warrants to its dealers, customers, and all subsequent purchasers
and users, that the products supplied by it shall be free from material defects in material
and workmanship for a period of one (1) year after shipment, provided they are installed and
maintained according to A
LUMAX B ATH E NCLOSURE 's recommended practices and installation
instructions. This warranty shall apply only to defects appearing within one (1) year from
the date of shipment, and provided that A
LUMAX
B
ATH
E
NCLOSURES
is promptly notified in
writing of such defects. The sole and exclusive remedy with respect to the above warranty
or with respect to any other claim relating to defects or any other condition or use of the
products supplied by A
LUMAX B ATH E NCLOSURES , however caused, and whether such claim is
based upon warranty contract, negligence, strict liability, or any other theory, is limited to
repair or supply of such products, or repayment by A
LUMAX
B
ATH
E
NCLOSURES
of the purchase
price paid for it, at A LUMAX B ATH E NCLOSURE 's option.
A LUMAX B ATH E NCLOSURES does not make any other representations or warranties, express or
implied, including, but not limited to, any implied warranty of merchantability and any
implied warranty of fitness for a particular purpose. In no event shall A
LUMAX B ATH
E NCLOSURES be liable for special, direct, indirect, or consequential damages, including, but
not limited to, loss or use of profits.
Dealers agree to pass on to its customers and users in writing A LUMAX B ATH E NCLOSURE 's
Warranty and Remedy as set forth above.
Laws and building and safety codes governing the design and use of bath enclosures vary
widely. A
LUMAX B ATH E NCLOSURES does not control the selection of product configurations,
operating hardware or glazing materials, and assumes no responsibility therefor.
INSTALLATION NOTES
Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts
using the instruction sheets as a reference. Before discarding the carton, check for small
hardware bags that tend to fall to the bottom of the box. If any parts are damaged or
missing, refer to the descriptions noted in the instructions when contacting your dealer for
r e p l a c e m e n t s .
Handle glazed panels carefully and protect the edges. Safety tempered glass is very
resistant to breakage, but the sharp corners of the panels can damage tile and floor
coverings.
Please wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile
or marble, use a center punch and hammer to carefully break the surface glaze so the drill
can start without skidding.
To install your A LUMAX Bath Enclosure you will need the following: tape measure, level, #2
Phillips screwdriver, flat screwdriver, drill, 1/8", 7/64" and 3/16" drill bits, hacksaw, pencil,
and caulking (clear silicone recommended). Optional tools include a miter box for cutting
parts to length, files, center punch and masking tape.
NOTE: Before beginning installation, check the tub rim for level and both walls for plumb.
If either are off more than 1/4" to 3/8", you may want to contact your dealer for tapered fillers
which can be used to level the tub track or plumb the wall jambs.