Alumax 750D - Manual (Page 6)

EPH-N00-06060
12-10-04
Page 6 of 8
7
NOTE: Obscure glass doors should be
installed with the rough surface of the glass to the
exterior of the unit. Deco or etched glass doors
should be installed with the patterned surface to
the inside.
On doors with obscure, deco or etched glass, there
is an interior and exterior glazed door panel [J] as
determined by the position of the top bearing fin.
Door panels with clear glass are interchangeable.
Attach the four heavy-duty roller bearings [K] to
the door panels as shown, using #8-32 x 3/8" hex
head screws [L] centered in the outside slots in the
top bearing fins.
8
Lift the interior door panel [J] (rough surface
away from the fin) into position with the roller
bearings [K] engaging the roller slot in the header
[H]. If the door panel is not parallel to the wall
jambs, remove and adjust the roller bearings up or
down to compensate.
Repeat for the exterior door panel (rough surface
closest to fin).
9
Place a nylon bushing [R] over the threaded shank
of the towel bar end cap. Slip a plastic washer [P] over the
bushing. Insert the threaded portion of the end cap [N] and
the bushing into one of the holes in the interior glass panel.
Place a second plastic washer then a metal washer [S]
over the threaded shank on the opposite side of the glass.
Screw the end cap into one end of the towel bar. Repeat
these steps for the other end of the towel bar and tighten
the end caps taking care not to damage the finish.
Repeat for the exterior panel.