Oil pressure check procedure, Preliminary check procedure – B&M 117302 4L60E TRANSMISSION User Manual

Page 7

Advertising
background image

OIL PRESSURE CHECK PROCEDURE

PRELIMINARY CHECK PROCEDURE

* CHECK TRANSMISSION OIL LEVEL
* CHECK AND ADJUST T.V. CABLE
* CHECK OUTSIDE MANUAL LINKAGE
* CHECK ENGINE TUNE
* INSTALL 0-300 PSI PRESSURE GAUGE
* CONNECT TACHOMETER TO ENGINE
* CHECK OIL PRESSURE AS FOLLOWS

MINIMUM T.V. LINE PRESSURE CHECK:
With the T.V. Cable properly adjusted and the brakes
applied, take the Line Pressure readings in the Ranges
and at the engine RPM’s indicated in the chart.

FULL T.V. LINE PRESSURE CHECK:
Full T.V. Line Pressure readings are obtained by holding the T.V. Cable to the full extent of it’s travel then take the
Line Pressure readings in the Ranges and at the engine RPM’s indicated in the chart.

CAUTION: Limit running time at FULL T.V. Pressure to two (2) minutes maximum to prevent overheating.

CAUTION: Brakes should be applied at all times.

Oil Pressure Tap Locations

4th Oil press Tap is not
present on all models

TH700-R4 TRANSMISSION OIL PRESSURES

MODEL

RANGE

NORMAL OIL PRESSURE

AT MINIMUN T.V.

NORMAL OIL PRESSURE

AT FULL T.V.

kPa

kPa

PSI

PSI

PARK, NEUTRAL,

OVERDRIVE,

MANUAL 3RD

@1000 RPM

REVERSE

@1000 RPM

*@2000 RPM

MANUAL 2ND &

MANUAL LOW

@1000 RPM

ALL MODELS SEE

NOTE BELOW

ALL MODELS SEE

NOTE BELOW

ALL MODELS SEE

NOTE BELOW

517-586

862-955

1517-1689

75-85

100-140

160-295

1145-1400

1869-2296

1517-1689

160-295

180-340

166-203

NOTE: Oil Pressure at FULL T.V. Pressure depends on the particular T.V. Boost valve and Line Bias Valve
arrangement of the unit. The Pressure reading obtained should be within the range shown.

Base Line Pressure is controlled by the Pressure Regulator Valve and Spring. Line Pressure is boosted a fixed
amount by the Reverse Boost valve when the selector lever is placed in Second or Low Range. The Line Pressure
is also boosted in Neutral, Drive, Drive3 and Reverse with throttle opening because of the T.V. system. The
pressure is controlled by the T.V. Cable via the throttle Lever and Bracket assembly to the Valve Body assembly.

The Line Pressure tap is located on the left side of the transmission case above the outside Manual Lever.

FIG. 8 Oil Pressure Check Procedure

7

Advertising