B&M 40227 TRANSPAK - Manual (Page 17)

cable assembly out of grommet on throttle body lever.
(See Fig. 20.)
6.3Using a small screwdriver, push out white locking tab.
6.4Check to ensure plastic block with pin and tab slides
freely on notched rod. If it does not slide freely, the
white tab may not be pushed out far enough. (See
Figs. 21 & 22.)
6.5While holding throttle lever firmly against its idle stop,
push grooved pin into grommet on throttle lever as far
as it will go. NOTE: While pushing pin into grommet,
make sure you do not move throttle lever away from
idle stop. (See Fig. 23.)
6.6Install air cleaner cover and air inlet tube.
7. Self-locking TV cable adjustment using TV Control
Pressure.
7.1Attach TV pressure gauge (0-60 PSI) T86L-70002-A or
equivalent to TV pressure tap (See Fig. 8).
7.2Obtain Cable TV Gauge tool T86L-70332-A or equiva-
lent.
7.3Insert tapered end of the tool between the crimped slug
on the end of cable and plastic notched rod, also on
end of cable assembly. Push in Cable TV Gauge Tool
T86L-70332-A or equivalent forcing the crimped slug
Figure 24
Figure 25
away from the plastic rod. Ensure gauge block is
pushed in as far as it will go. (See Fig. 24.)
WARNING: THIS PROCEDURE REQUIRES WORK-
ING IN CLOSE PROXIMITY TO THE EGR SPACER
ASSEMBLY WHICH MAY BE HOT.
7.4Operate engine until normal operating temperature is
reached. The transmission fluid temperature should
be approximately 38-72
o C (100-150 o F). Do not make
pressure check if transmission fluid is cold or too hot
to touch.
7.5Set parking brake and place shift selector in NEU-
TRAL. With gauge tool in place and engine idling in
NEUTRAL, the TV pressure should be between 207
and 276 kPa (30 and 40 psi). NOTE: Do not check or
set TV pressure in PARK.
7.6If TV pressure meets specification in Step 5, remove
gauge tool allowing cable to return to its normal idle
position. With engine still idling in NEUTRAL, TV
Figure 27
Figure 26
17