B&M 40227 TRANSPAK - Manual (Page 18)

pressure must be at or near zero (less than 34 kPa (5
psi)).
7.7If TV pressure does not meet specification in either or
both Steps 5 and 6, remove gauge tool and readjust
cable as outlined under Self-locking TV Cable Adjust-
ment. Then repeat steps 3 through 6.
7.8If TV pressure still does not meet specification, it will
be necessary to modify adjustment as follows.
7.9Remove gauge tool and pry grooved pin out of grom-
met on throttle lever. (See Fig. 25.)
7.10 Mark or measure location of plastic block on
notched rod. (See Fig. 26.)
7.11 Push out locking tab. (See Fig. 27.)
7.12 Using mark or measurement on plastic block as a
reference, move plastic block towards throttle body
mounting bracket to raise TV pressure, or move it
away from bracket to lower TV pressure. Push in
white locking tab to lock block in position. (See Fig.
28.)
7.13 Insert grooved pin back into grommet. (See Fig.
29.)
7.14 Check TV pressure. Refer to Steps 3 through 6.
NOTE: For best transmission function, the TV pres-
sure should be set as close as possible to 227 kPa (33
psi) in NEUTRAL with gauge tool installed. Since the
TV pressure goes up approximately 14 kPa (2 psi)
when the shift lever is moved from NEUTRAL to a
forward gear, this will result in a TV pressure setting
near the desirable 241 kPa (35 psi) in forward gear.
Do not attempt to check TV pressure with the
transmission in gear. When the gauge tool is re-
moved, the TV pressure should drop to less than 34
kPa (5 psi). If the TV pressure does not drop to less
than 34 kPa (5 psi), reset the TV pressure to a value
less than 227 kPa (33 psi) with gauge tool installed but
no less than 207 kPa (30 psi). Verify that the TV
pressure is less than 34 kPa (5 psi) with gauge tool
removed.
LOCK TAB
Figure 28
18
THEN PUSH IN LOCK TAB
Figure 29
TOOL LIST
Hydraulic jack
Gasket scraper
Jack stands or Wheel ramps
3/8" Drill motor
Oil drain pan
Fine cut flat file
3/8" drive ratchet wrench
Wet or Dry sand paper
3/8" drive, 4" extension
Grease or petroleum jelly
8mm, 10mm, 13 mm, Sockets
Needle nose pliers
Torque wrench
Small flat screwdriver
Funnel
PARTS LIST
Separator plate 1
Spring, Red Pressure regulator 1
Spring, Green 1-2 capacity modulator valve 1
Spring, Yellow 1-2 capacity modulator valve 1
Spring, blue 2-3 accumulator 1
Spacer, gold 2-3 accumulator 1
Seal ring 2-3 accumulator 1
Seal ring 2-3 accumulator 1
Drill 1/8" 1
Alignment pin 2
Screw M4 X .7 X 10 1
Nut M6 hex 2
Gasket Plate to case 1
Gasket Plate to valve body 1
Gasket Oil pan 1
Gasket Oil filter 1
Oil filter 1