B&M 40227 TRANSPAK - Manual (Page 5)

5
shown. ( See Fig 5.) Align both sepa-
rator plate holes and tighten the (2)
bolts until they are just snug.
STEP 9. Using the stock separator
plate as a template drill holes in the
B&M AOD separator plate as indi-
cated in Figure 5.
Remove all sharp burrs from plate
surface with a fine flat file. Burrs can
be removed from around the edge of
the holes by lightly pressing a slightly
larger drill bit to the hole and spinning
it with your fingers.
IMPORTANT: Drill only in the areas
indicated. There are other holes in
the stock separator plate that are not
used with this kit and should not be
drilled in the B&M plate.
STEP 10. Wash and wipe any loose
chips from B&M separator plate.
DOUBLE CHECK the stock plate
against the B&M plate to make sure
all required holes have been drilled.
VALVE BODY ASSEMBLY
STEP 11. Check ball placement (See
Fig. 4) Place check balls in the valve
body in the positions shown. Use a
dab of grease or petroleum jelly to
hold check balls in position. The
grease will have no effect on trans-
mission operation and will dissolve
after an hour or two of operation. Note
the location of the ORANGE #1 check
ball. The orange and black check
balls are not interchangeable.
STEP 12. Reinstall original converter
and TV pressure relief springs and
valves (See Fig. 4). Pay close atten-
tion to the spring color and relief valve
stem length. The long stem converter
relief valve can have either a green or
Install bolts and nuts in holes
marked "X" for alignment during
drilling
Figure 5
X
A
X
C
B
C
The stock separator plate will have one of the follow-
ing:
1. No holes or slots at A, B or C.
2. A slot at position A only.
3. Slots at positions A and B, and holes at position C.
Using existing slots and holes as templates, drill two
holes as shown using 1/8" drill supplied in kit.
If your stock separator plate has no holes or slots in
these positions (A, B or C) then the B&M plate will not
have to be drilled. The existing holes at position C may be larger or
smaller than 1/8" (.125"). That's OK. If these holes are
present on your separator plate use them as tem-
plates to drill 1/8" holes in the B&M separator plate.
NOTE: There will be holes and slots in the stock
separator plate which have no corresponding holes or
slots in the B&M separator plate. They are not re-
quired for operation of B&M AOD Transpak.