B&M 40505 BRACKET AND LEVER KIT, 4R100/E40D - Manual (Page 5)

STEP 12. Verify inner shift lever moves through
every position.
STEP 13. Replace the oil fi lter. We recommend that
you use a new fi lter unless the vehicle has very low
mileage. Replace the oil pan gasket with a new
gasket. Replace the original bolts except for the two
that secure the cable bracket. The cable bracket is
installed with the supplied bolts with spacers between
the bracket and the pan. Tighten the oil pan bolts to
12-16 ft-lbs.
TOOLS: Torque Wrench, Drive, Extension,
& sockets (10 & 13mm).
STEP 14. With selector shaft in neutral position,
Install Neutral Position Sensor. (NOTE:
replace Neutral Position Sensor in same
orientation as found before removal).
Align sensor to neutral position before
tightening two (2) 8mm bolts.
* Use selector lever to rotate Selector
Shaft to neutral position.
STEP 15. Secure B&M Selector Lever onto B&M
Selector Shaft with M10 bolt and M10
washer.
TOOL: Wrench (17mm).