Brondell Swash 550 - Manual (Page 3)

Flat head screwdriver
Phillips screwdriver
� � � � �� � CAUTION
2
�
� �
�
�
�
��
Some toilets may not provide adequate access to the seat mounting holes preventing proper installation
of the Standard Mounting Hardware.
In this case, you will need to use the Alternate Mounting Hardware and follow the enclosed instructions.
Check the line that connects the toilet tank to the water shut off valve. If it is a rigid pipe, you may need to
purchase a flexible hose to replace it before installing the Swash 450 / 550. The length of the hose and the
size of the connectors will vary.
Installation
Before Installation
Tools Needed
Alternate Mounting Hardware
Check Water Supply Line
� � � �
�
You may wish to place a container under
the tank to catch any leaking that could
occur during installation.
a) Turn water valve off completely.
b) Flush the toilet to empty the tank.
c) Disconnect water supply line from toilet tank.
IMPORTANT: Do not continue without completing these
steps! Failure to do so could result in flooding, leaking, or
damage to the Swash 450 / 550.
�
� �
2) Turn Water Off and Flush Toilet
� �
� �
� �
Please read these instructions carefully before installing the Swash 450 / 550.
Failure to do so could result in flooding, leaking, or damage to the product.
1) Remove Toilet Seat
a) Lift hinge covers and use a screwdriver
to remove the mounting bolts.
b) Remove the toilet seat.
Steps may vary by type of seat.
� �
� �
NOTE: The included Universal Wrench will work for most applications. Depending on your toilet
configuration, an adjustable wrench may also be needed.
Univeral Wrench (included)
Measuring tape
�
� �
3) Install Mounting Plate
NOTE: The following instructions are for standard Mounting
Hardware.
Refer to separate instructions for Alternate
Mounting Hardware.
a) Place Mounting Plate over mounting holes,
flat side down, curve toward the back of toilet.
b) Insert bolts through the Mounting Plate and loosely tighten
the wingnuts. Make sure the crush washer is positioned
with the tapered end up (see graphic).
� � � � � �� � �� � �� �
� �
� �