Brondell Swash 550 - Manual (Page 7)

6
Power Save Mode
Operation
(continued)
Adjusting Seat, Water, and Dryer Temperature
Adjusting Seat Temperature
Press SEAT TEMP button to adjust temperature. Repeat until desired level is achieved.
There are four temperature levels: low>medium>high>off . No LED light up when
seat heating is off. Each LED display represents one level increase.
Adjusting Water Temperature
Press WATER TEMP button to adjust temperature. Repeat until desired level is achieved.
There are four temperature levels: low>medium>high>off No LED light up when
water heating is off. Each LED light display represents one level increase.
Adjusting Warm Air Dryer Temperature (available in S550)
While seated,press WARM AIR button to adjust temperature. Repeat until desired level
is achieved. There are three temperature levels: low>medium>high Each LED light
display represents one level increase.
NOTE: Temperature settings are stored in
memory according to last settings
seat temp
seat temp
warm air
power powersave
4h 6h 8h 10h
2h
power powersave
4h 6h 8h 10h
2h
You can turn off the seat and water warming features temporarily (between 2 - 10 hours)
by initiating Powersave in the Swash 450 / 550. For longer periods of non-use, unplug the
Swash 450/550 to conserve energy.
Setting Powersave Start and End Times
a) Press the POWERSAVE button on the remote control for over 3 seconds. This will
activate SETTING MODE and POWER LED will begin flashing.
b) While in SETTING MODE, press the POWERSAVE button through the cycle
(between 2 - 10 hours), each LED display light (located above the POWERSAVE
button) represents an increment of 2 hours of powersave.
c) Powersave mode will be engaged when buttons have not been pressed for 5
seconds. The POWER LED and FLOW / TIMER LED will flash continuously while
the Swash 450/550 is in Powersave status.
d) Powersave mode will cancel automatically, when the programmed Powersave
duration (between 2 - 10 hours) is completed.
When Powersave is Operating
a) Sitting on the Swash while it is in Powersave mode will not return the unit to normal
operation.
b) To return the Swash into normal operation, press either the STOP or POWERSAVE
button once.
c) The Swash will not re-enter into Powersave until user proceeds to set the powersave
setting again.
stop powersave
or