Brondell Swash 550 - Manual (Page 5)

4
Installation
(continued)
7) Filling the Reservoir
Sit on the Swash 450 / 550 to activate the seat switch. Press one of the wash functions on the control.
The reservoir will begin to fill. It will take between 20 and 40 seconds for the reservoir to fill
completely.
When the reservoir is full, the wash wand will extend and begin to spray. Push STOP to cancel the
wash function.
Your Swash is now ready for use!
Troubleshooting
1
2
3
4
5
6
7
8
9
Issue Possible Causes � Solution
Low water flow or 1) Clogged filter 1) Clean filter
pressure 2) Twisted hose 2) Straighten the hose
3) Household water pressure low 3) Increase water pressure to the Swash
Nozzles do not function 1) Nozzles are dirty 1) Clean the nozzles
properly 2) Clogged filter 2) Clean the filters
3) Water pressure is too low 3) Adjust water pressure
Nozzles fail to retract Nozzles are dirty Clean the nozzles
Washing feature does 1) User not properly seated 1) Adjust your sitting position
not work or fails to spray 2) Seat Switch not contacting toilet 2) Make sure seat switch is contacting
fixture correctly toilet bowl (switch is in seat foot)
Product shuts off 1) Washing time exceeded 5 minutes 1) Repeat Cleaning function
during use 2) Power failure 2) Check power and/or unplug the
cord to reset
Seat not heated Seat temperature set to off Reset heated seat temperature
Water not heated Water temperature set to off Reset heated water temperature
Water flow sporadic Pulsating / Spa mode activated Reset to normal washing mode
or inconsistent
Dryer not working Dryer only operates when Sit on product to operate Dryer
(available in S550) activated by weight of person
�