Brondell FreshSpa Dual Temperature Bidet - Manual (Page 10)

Installation
Step 5d-1
Step 5d-2
Step 5e-2
d) Connect Hot Water T-valve to water supply
1. Install the Hot Water T-valve and the small
rubber washer onto the hot water shut off
valve under the sink.
2. Reconnect hot water supply line to open
end (top) of T-valve (use the second small
rubber washer if needed).
e) Connect Hot Water Flex Tubing to T-valve
1. Remove brass pressure cap from open end
of T-valve and pop out small plastic plug to
open the hole.
2. Slide brass pressure cap over one end of Hot
Water Flex Tubing with inside screw threads
facing out.
3. Push Hot Water Flex Tubing onto open end
of T-valve (onto the pressure connector) until
tubing cannot go any further. It’s important
to make sure the tubing slides past the “lip” of
the pressure connector.
4. Slide the brass pressure cap down the Flex
Tubing and screw onto the T-Valve until secure
and tight, use caution not to over tighten this
connection and damage the tubing!
8