Brondell FreshSpa Dual Temperature Bidet - Manual (Page 7)

5
Installation
Check the size of the hot water supply connection (most likely
under the sink/wash basin). This needs to be a 3/8” connection
for our T-valve to install. Note: if the connection is a ½”
connection, you will need to purchase the following reducing
adapter available online and at many plumbing hardware stores:
Reducing Adapter, ½” Female NPT X 3/8” Male Compression.
Check Water Supply Line: Check the water supply line that
connects the toilet tank fill valve to the water shutoff valve at
the wall. If it is a rigid pipe, you will need to purchase a flexible
water supply hose to replace it before installing the FreshSpa.
The length of the hose may vary and the top connection size
should be 7/8” Ballcock to connect to the T-valve that you will
install under the toilet tank and the bottom connection will vary
(most common are 3/8” and1/2”female compression).
1) Remove Existing Toilet Seat
a. Lift hinge covers and use flathead or Phillips head screwdriver
to remove the mounting bolts. Alternatively, you may need to
loosen mounting bolts underneath the seat.
b. Remove the toilet seat and set the seat, mounting bolts and
hardware aside.