CASO Germany WineSafe 18 EB - Manual (Page 31)

caso Wine Safe 18EB 31
Returning the packaging back to the material loop saves raw materials and reduces
the quantities of accumulated waste. Take any packaging materials that are no
longer required to “Green Dot” recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
10.5 Setup
10.5.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
• Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
• Ambient temperature below 0°C or above 38°C will hinder the performance of the
appliance.
• This unit is not designed for use in a garage or any other outside installation.
• Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
• Do not cover up any openings on the device and do not block these off.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
• For energy saving reasons please ensure that the door is closed when the appliance is
turned on.