CASO Germany WineSafe 18 EB - Manual (Page 40)

caso Wine Safe 18EB 40
13.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault Possible Cause
Wine refrigerator do not operate. Not plugged in using different voltage. The
circuit breaker tripped or a blown fuse.
Wine refrigerator is not cold enough. Check the temperature control setting.
External environment may require a higher
setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct
clearance.
The light does not work. Check the service center.
Vibrations. Check to assure that the wine refrigerator is
level.
The wine refrigerator seems to make to
much noise The wine refrigerator is not level.
The door will not close properly. The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak.
The shaves out of position.
LED could not display. Main control board does not work.
PCB Problem.
There is some problem with the plug.
LED display error - Lo Weak quality of display.
Temperature point is out off. Check the service
center.
Bottoms are not functional. Temperature controller panel is damaged.
Compressor will not start Room temperature is lower than desired
temperature.
Compressor re-start Compressor will stop working when cooling
system in the cabinet reaches presetting
temperature, and re-start working until the
desired temperature is achieved. Allow a
minimum 5 minute interval before re-starting.