Catler ES 8013 - Manual (Page 34)

34
CLEANING THE STEAM WAND
CARE & CLEANING
The steam wand should always be cleaned
after texturing milk.
•
Wipe the steam wand with a damp cloth,
and then with the steam wand directed
back into the drip tray, briefl y set the
steam dial to the STEAM position. This
will clear any remaining milk from inside
the steam wand.
• Ensure the steam dial is in the STANDBY
position. Press the POWER button to Off
and allow the machine to cool.
• If the steam wand remains blocked, use
the pin on the cleaning tool to clear the
opening.
• If the steam wand continues to be
blocked, the tip of the steam wand can
be removed by using the spanner in the
middle of the cleaning tool.
• Unscrew the tip with the cleaning tool.
• Soak the tip in hot water before using the
pin on the cleaning tool to unblock.
Replace the tip back onto the steam
wand and secure with the cleaning tool.
CLEANING / UNBLOCKING THE FILTERS, PORTAFILTER AND GROUP HEAD
Periodically run water through the machine with the portafi lter in place, but without any
ground coff ee, to rinse out any residual coff ee particles.
Should the fi ne holes in the fi lters become
blocked follow the following steps:
1. Place the fi lter into the portafi lter. Run
water through the machine with the
fi lter and portafi lter, without any ground
coff ee, in place.
2. The fi ne pin on the cleaning tool can be
used to clear the fi lter basket holes.
3. To clean the Single Wall fi lters simply run
water through the portafi lter using the
manual pour function by holding down
the 1 CUP button.
4. For a thorough clean of the fi lters, run
a cleaning cycle of the machine with the
portafi lter and fi lter in place.