Catler MF 8010 - Manual (Page 12)

12
OPERATING YOUR MILK FROTHER MF 8010
Using the ‘Cold Stir’ setting
By selecting the ‘Cold Stir’ setting on the
temperature dial, you can froth cold or hot milk
without heating.
The ‘Cold Stir’ setting is ideal for making cold
beverages or blending ingredients.
The ‘Cold Stir’ setting will operate for 60 seconds.
NOTE:
Avoid adding sugary powders using
‘Cold Stir’ setting. Toppings and syrups
work best.
Adding ingredients
Using the measuring cap, gradually add ingre-
dients a few minutes after the stirring cycle has
commenced, allowing the milk to warm fi rst.
Always add ingredients slowly and in small
quantities. Adding ingredients too quickly may
cause the frothing disc to dislodge or stop spin-
ning.
NOTE:
A different frothing result may be
achieved depending on the ingredients
added.
Experiment with different milk op-
tions, ingredients and frothing discs to
achieve the desired result.
Safety features
• Standby Mode
After 30 seconds of non use the milk frother will
enter standby mode and the button surround
will cease to illuminate.
To activate the milk frother out of standby mode,
press the START | STOP button.
• Boil Dry Protection
The milk frother will automatically cease to oper-
ate if the jug overheats. This can be caused if the
jug is empty, if liquid is below the MIN measure-
ment marking, or after consecutive uses. Wait
approximately 5 minutes for the milk frother to
cool down or fill the jug with water for faster
cooling.
Once adequately cooled, you will be able to acti-
vate the milk frother and recommence frothing.
• Thermal Fuse Protection
This feature protects the milk frother in case of
major fault.
The appliance will no longer be able to operate.
Immediately cease use and contact the
authorised Catler service centre.
152185_MF_8010_EN_.indd Odd1:12 152185_MF_8010_EN_.indd Odd1:12 6.5.11 16:41 6.5.11 16:41