Catler MF 8010 - Manual (Page 15)

15 15 15 15
CARE AND CLEANING
CARE AND CLEANING
1. Make sure the device has been switched off
by pressing START/STOP button. The device
is switched off if push-dial backlight has
gone off. Unplug the power cord from the
power outlet before cleaning.
2. The jug and frothing disc will be hot after
use. Wait for jug and disc to cool before
rinsing in tap water.
3. Wash the jug, jug lid, measuring cap and
frothing disc in warm soapy water, rinse and
dry thoroughly.
4. The seal from the lid can be removed and
washed separately.
5. Wipe exterior of appliance with a soft, damp
cloth. Then dry thoroughly.
NOTE:
Let the jug and frothing disc cool down
thoroughly before disassembling and
cleaning.
NOTE:
Do not use alkaline or abrasive cleaning
agents, steel wool or scouring pads as
these can damage the surface.
NOTE:
Only the jug, jug lid, measuring cap
and frothing discs can be washed in the
dishwasher (top shelf only).
WARNING:
NEVER IMMERSE THE POWER BASE IN
WATER OR ANY OTHER LIQUID. DO NOT
EXPOSE THE DEVICE OR ANY ITS PART
TO MOISTURE.
NOTE:
USE A SOFT CLOTH AND MILD DETER-
GENT TO CLEAN THE APPLIANCE.
Storage
1. Ensure the appliance is switched off, cleaned
and dried before storing.
2. Ensure the jug is clean and dry.
3. One of the frothing disc can be stored onto
the shaft at the base of the jug and the other
disc can be attached into the “On Board”
Disc Storage.
4. Wrap the power cord around the power cord
storage under the power base.
5. Store the appliance upright position. Do not
place anything on top.
152185_MF_8010_EN_.indd Odd1:15 152185_MF_8010_EN_.indd Odd1:15 6.5.11 16:41 6.5.11 16:41