CellarPro AH6500 - Manual (Page 10)

10
Step 7: Re-assemble the humidifier components.
Place the water panel back into the humidifier. Make sure the water discharge tube inserts into the water panel
top opening, and the water panel bottom drain is aligned with the housing drain. Replace the internal screen and
humidifier access cover.
Step 8: Mount and connect the humidistat.
Mount the remote humidistat inside the cellar near the return air plenum, at a convenient height to access the
display. Loosen the cover screw and separate the front housing from the base:
- Run the humidistat
lead wire through the
back hole to the
terminals.
- Install the mounting
plate using two wall
mounting screws.
- Connect wiring by
matching the wire lead
color to the terminals as
shown.
- Replace the cover.
Step 9: Getting started.
Power up the unit and set the humidistat to turn the humidifier on, and verify that water is flowing through to the
drain. The humidifier is now ready to put into service.
Cover screw