BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 11)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 11
C. Connect the 19” water line on the turbo charger
to the back of the motor and fasten with the
factory clamp
D. Trim the protective plastic cover right before the
clamp. We will use this later.
E. Route the 17” water line from the turbo to the
stock water line that you just pinched off. Trim
the factory water line to proper length and
connect the factory water line to the 17” turbo
water line using the supplied ¼” barb and fasten
with the 2 #4 hose clamps provided in the kit (as
shown in picture).
\
C. Install the piece of trimmed plastic sleeving on
the upper side of the water line, this will keep
the hose from rubbing on any sharp edges (see
picture).