Iii. control box mounting locations, Iv. control box operation – BoonDocker YAMAHA: Phazer User Manual
Page 3
BoonDocker – 1585 Hollipark Dr. Idaho Falls, ID 83401 – 208-542-4411 / 877-522-7805
www.boondockers.com – email:
– fax: 208-524-7381
Revised 05-07-07
Page 3 of 16
C. Jumper/Battery Connector
The jumper can be used in one of the following two ways:
1. A 9-volt battery can be plugged into the jumper and
the jumper can be plugged into the female connector
(pressure transducer connector must be unplugged)
to power the Control Box. This allows the Control
Box to be turned on when the engine is off.
2. If the Control Box is unplugged from the injector
harness, the jumper can be plugged in its place into
the injector harness (9-volt battery is not required).
This bypasses the Control Box to allow the sled’s
ECU to directly drive the injectors. This is for
emergency or diagnostic use only!
III. Control Box Mounting Locations
The Control Box can be mounted under the hood, on the dash, or on the handlebars using the supplied Velcro strips.
Before applying the adhesive strips, thoroughly clean each surface (rubbing alcohol works well). It is also best if each
surface is room temperature.
If the box is mounted under the hood, keep the box away from excess heat (like the exhaust), and away from the ignition
coil.
Note: The Control Box is designed to be splash proof. Do not submerge or subject the box to high-pressure spray.
IV. Control Box Operation
The control box is powered only when the injectors are on which occurs for a few seconds when the key is first turned on
or when the engine is running. Up to 5 different fuel adjustment maps are stored in the box (currently all with zero values).
The box will remember what map was last selected and what its settings are – you do not need to do anything to save a
map when making adjustment (see Fuel Adjustments below).
A. Intro / Startup Screen
When the box is first turned on (by the engine or battery), the Intro screen is displayed. Press any key to go to the main
menu. An example Intro screen display is shown below:
Phazer Turbo
4B5gBD N2O:FIX
In the example shown above, this screen displays the following information:
Phazer Turbo
Sled model. This box is designed for the Yamaha Phazer. Boxes for other sleds will
have other lettering.
4B5gBD
This is the software version of the box. The box can be reprogrammed only by sending
the box back to Boondocker
N2O:
Shows that this Control Box is nitrous capable.
FIX
Nitrous pressure regulator type (refer to Nitrous Section for more description)