BoonDocker YAMAHA: Phazer - Manual (Page 6)

BoonDocker – 1585 Hollipark Dr. Idaho Falls, ID 83401 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 05-07-07 Page 6 of 16
16: fuel adjustment is centered at 16 psi. If pressure is below 16, fuel is blended with 12 setting. If pressure is
above 16, fuel is blended with 20 setting.
20: fuel adjustment is centered at 20 psi. If pressure is below 20, fuel is blended with 16 setting.
24: fuel adjustment is centered at 24 psi. If pressure is below 24, fuel is blended with 20 setting. If pressure goes
above 24psi, fuel is kept at this setting.
1.C Fuel: Accel Pump Adjustments M1L
Æ
AM DR Sens
ACEL 00 00 00
.
AM
Amount of fuel to be added/subtracted during acceleration
DR
Duration in engine cycles to make acceleration adjustment
Sens
Accelerator pump Sensitivity. Larger values are Less sensitive (throttle must be moved more). Value of
Zero will cause accelerator pump to always be on! Typical values are between 5 and 20.
2. Map / Setup Menus
From the Main Menu, select Map1U to go to the Map Menu (shown below). This screen is used to
Load/Copy/Lock/Unlock saved “maps” that contain fuel and N2O settings. Five maps can be used (Map1-Map5).
Lock ULock StUp
Æ
Load Copy Quit
2.1 Map: Load
When a new map is loaded, the current adjustment settings will be changed to the values from that map. To load a
new Map, first move the cursor to select Load and press “SEL”. The following Load/Lock Menu will be
displayed:
Load 1 2 3 4 5→Q
Lock L U U U U Q
Load 1-5
Selects which map to load
Lock
L = Locked, U = Unlocked, applied to the map number the L or U is under
Q
Quits this menu
Use the Up/Down and Left/Right Arrow keys to move the cursor around. To load a new map, move the cursor to
the desired map number and press “SEL.” The map will be loaded and the Main Menu will be displayed. When a
map is loaded, the Mx (x is the map number) that is displayed in the Main and Fuel menus will show the loaded
map number as a reminder.
To quickly Lock or Unlock maps, move the cursor down to the Lock row, place the cursor under the L or U by the
desired map number, and press “SEL” to change a U (Unlocked) to an L (Locked) or vice versa.
Select Q to Quit and return to the Main Menu.
2.2 Map: Copy
To copy a map, first select Copy from the Map Menu. The following Copy/Lock Menu will be displayed:
Copy 1 2 3 4 5→Q
Lock L U U U U Q
Copy 1-5
Selects which map to copy the current map TO
Lock
L = Locked, U = Unlocked
Q
Quits this menu
This screen is used to save the CURRENT fuel adjustment map TO one of five available map locations. The map
that is being copied TO must be Unlocked – otherwise a message will be displayed telling you that the map you
selected cannot be overwritten.