BoonDocker POLARIS: Non-turbo Control Box 900 IQ - Manual (Page 3)

BoonDocker – 2379 Heyrend Way Idaho Falls, Idaho 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email: [email protected] – fax: 208-524-7381
Revised 11-07-07 Page 3 of 16
1. Battery Connector
The Control Box is designed to operate without a battery – the box
will turn itself on whenever power is applied for the fuel injectors.
However, a 9-volt battery (not included) can be plugged into the box
through the Control Box’s connectors with the supplied battery /
jumper connector in order to operate the box without the sled
running. This battery connector plugs into the Control Box’s nitrous
connector (refer to picture below). Secure the battery to the
connector with a zip tie in order to provide a strain relief for the 9-
volt connector. The battery can also be secured to part of the
harness if it is to be used on the sled while it is running.
The battery connector can be left plugged in during engine
operation, but the nitrous harness (if used) cannot be plugged into
the Control Box. The battery will eventually drain if left connected
to the box, so it is best to disconnect the battery when not in use.
2. Jumper Connector
The Battery/Jumper connector can also be used to bypass the Control Box in case the sled needs to be run without the
Control Box. Disconnect the Control Box from the EFI harness and plug in the Jumper connector - the injectors are now
connected directly to the sled’s ECU.
IV. Control Box Menus
1. Startup Screen
Every time the box is first turned on (by the engine or battery), the Startup Screen is displayed. Press any key to go to the
Main Menu. An example Startup Screen is shown below:
Polaris 600-700
xxxxxxxx N2O:ADJ
.
In the example shown above, this screen displays the following information:
Polaris
Sled make
600-700
Sled model Note: Be sure the Control Box is for your make and model of sled!
xxxxxxxx
Code Version This is the version of code in the box. The version of code can only be changed
by sending the box back to Boondocker.
N2O:
Shows that this Control Box is nitrous capable.
ADJ
Nitrous pressure regulator type (if used). This mode is described below in the Nitrous Section.
2. Main Menu
The Main Menu is shown below:
Main

Fuel Stats
Menu N2O Map1U
The current selection is shown by the Right-Arrow and the cursor (underscore below the “F”). Use the arrow keys to
move the cursor. Move the cursor to the desired selection and press the “SEL” key to select the desired menu option from
one of the following:
Fuel Go to the Fuel adjust menus.
Stats Display runtime data, captured data, and recorded maximum data.
N2O Menus for optional Boondocker Nitrous kit.
Map Go to the Map menu.
The current Map number is displayed as “Map1U”. This indicates that map number 1 is being used and it is Unlocked.