Code 3 RockerPak 410, 416, 426 - Manual (Page 3)

3
Safety First
Installers should keep in mind the importance of safe installation to protect the lives of those who may depend
upon this equipment. Please read all instructions supplied with this equipment. Listed below are some other
important safety instructions to follow:
To properly install the equipment described in this instruction sheet: you must have a good
understanding of automotive electrical procedures and systems, along with proficiency in the
installation and use of safety warning equipment.
Locate the switch module so the vehicle and controls can be operated safely under all driving
conditions.
When drilling into a vehicle structure, be sure that both sides of the surface are clear of anything
that could be damaged.
Keep these instructions in a safe place and refer to them when maintaining and/or reinstalling the
product.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death
to you or others.
Unpacking & Pre-installation
Carefully remove the Switch Control from the shipping carton and place on a flat surface, taking care not to
damage the wire cable coming out of the back of control box. Examine the unit for transit damage, dented
cover, ect.. If convenient, you may wish to bench test the unit before installing. Before applying voltage to the
bar, be sure you have read and understand the wiring instructions on page 5.
FIGURE 2