Code 3 RockerPak 410, 416, 426 - Manual (Page 6)

6
To properly wire the switch module, see the wiring diagram shown in figure 3 and perform the following
procedures:
1) Use 12 AWG wire and connect leads "1" through "6" to the applicable accessory
load. Remember: lead "1" corresponds to switch "1", lead "2" to switch "2", and so
on.
2) Use 18 AWG wire and connect the ground (earth) lead "G" to a reliable ground
(earth). Each switched device must be grounded with a separate ground (earth) wire.
3) Use 18 AWG wire and connect the backlighting circuit lead "B" to the accessory
terminal of the ignition switch or the vehicle instrument light circuit.
4) Power for the switch module may be obtained from a vehicle power distribution
center (TSD part number D1X1F-PD90) or by a 60, 80, or 100 amp master circuit
breaker (call TSD for part number required). We recommend that all circuits be
protected by fuses or circuit breakers. Installation of a power distribution center or
master circuit breaker should be placed near the battery. Use 8 AWG wire and
connect the power distribution center. If power is obtained in the engine
compartment, a hole will probably have to be drilled into the vehicle firewall. Place a
grommet or similar device in the hole to protect the wire (S) against damage from
rough edges.
CAUTION: When drilling holes in any part of any of the vehicle, ensure that both sides of the surface are clear
of parts that could be damaged: such as brake lines, electrical wiring, fuel lines, or any other vital part of the
vehicle.
Parts List
Description Qty.
1/4" - 20 x 5/8" bolts 2
1/4" lock washer 2
wire ties 2
insulated 1/4" male terminals (yellow) 7
insulated 1/4" male terminals (pink) 2
legend inserts, (TAKE DOWN, GRILLE LIGHTS, DECK LIGHTS, 8
STROBE,AUX., WIGWAG, FRT/REAR FLASHER, (CENTER &
SWEEPS))