Code 3 Z3 Siren Installation & Operation Manual - Manual (Page 11)

11
CC ArrowStik Connection
The Z3 Siren can connect directly to any Code 3 Centrally Controlled (CC) ArrowStik and some non-Code3 CC ArrowStiks using Code 3 harness
P/N T56629 (see Figure 8). This harness is found in the Harness & Cable Bag P/N T56641. Refer to the wiring diagram on page 15.
Conventional ArrowStik Connection
The Z3 Siren can also connect directly to a conventional ArrowStik or both at the same time using Code 3 harness P/N T56631 (see Figures 6 & 7).
Refer to the wiring diagram on page 15. If a conventional ArrowStik is desired see the Z3 Siren Confi guration Software Manual for details regarding
fl ash pattern selection.
The 9 wire harness can be connected to drive a 5, 6, or 8 head ArrowStik. The Z3 Siren is compatible with some non-Code 3 ArrowStik products.
The Z3 Siren conventional ArrowStik outputs provide a current sink (ground) signal when active. Each output is rated for a maximum of 5 amps. See
the wiring diagram on page 15 and the install manual for the ArrowStik product for wiring details.
8 HEAD HARNESS CONNECTIONS
When viewing the vehicle from the rear, the ArrowStik harness is connected in the following order from Driver side to Passenger side: Blue, Yellow,
Gray, Green, Violet, Tan, Orange, Brown. The Right Arrow travels from Blue to Brown. The Left Arrow travels from Brown to Blue.
6 HEAD HARNESS CONNECTIONS
When viewing the vehicle from the rear, the ArrowStik harness is connected in the following order from Driver side to Passenger side: Yellow, Gray,
Green, Violet, Tan, Orange. The Right Arrow travels from Yellow to Orange. The Left Arrow travels from Orange to Yellow.
If the Z3 Siren ArrowStik function is confi gured for ArrowStik End Flash, the Blue and Brown wires will attach to the two end light heads.
5 HEAD HARNESS CONNECTIONS
When viewing the vehicle from the rear, the ArrowStik harness is connected in the following order from Driver side to Passenger side: Yellow, Gray,
Violet, Tan, Orange. The Right Arrow travels from Yellow to Orange. The Left Arrow travels from Orange to Yellow.
If the Z3 Siren ArrowStik function is confi gured for ArrowStik End Flash, the Blue and Brown wires will attach to the two end light heads.
DIM Control
The Z3 Siren DIM function supplies +12VDC output when active. This output is compatible with the dimming input of older Code 3 ArrowStik
products. It is not used with newer Code 3 ArrowStik products. This output can supply an absolute maximum of 1.5 amps.
Programming
The Z3 Siren will come from the factory set to control a CC ArrowStik. For details about ArrowStik pattern selection for Code 3 CC ArrowStiks, refer
to the ArrowStik user manual. For an conventional ArrowStik, refer to the Z3 Siren Confi guration Software Manual.
The Z3-SWIF Connection
The Z3 Siren can be connected to the Z3-SWIF using a standard CAT-5 cable (P/N T56649) plugged into the AMP-2 Port on the Amplifi er. See the
Z3-SWIF Installation Manual for instructions on confi guring the Z3-SWIF.