Cabletron Systems 6C105 - Manual (Page 32)

Chapter 3: 6C105 Setup
3-12 6C105 Overview and Setup Guide
Figure 3-6 Power Supply DC ON/OFF Switch and DC Input Power Strip
DC Power Supply Requirement for Each Supply
Each DC power supply input requires either a 48 VDC or 60 VDC power
source, rated at a minimum of 17 Amps.
ONLY QUALIFIED PERSONNEL SHOULD PERFORM THESE
INSTALLATION PROCEDURES.
TO REDUCE THE RISK OF ELECTRIC SHOCK OR ENERGY
HAZARDS:
• CONNECT TO A RELIABLY GROUNDED 48/60 VDC
SELV SOURCE.
• ENSURE THE BRANCH CIRCUIT OVERCURRENT
PROTECTION IS RATED AT A MINIMUM
OF 25 A.
• USE 10 AWG SOLID COPPER CONDUCTORS ONLY.
• ENSURE THAT A READILY ACCESSIBLE
DISCONNECT DEVICE THAT IS SUITABLY
APPROVED AND RATED, IS INCORPORATED IN
THE FIELD WIRING.
TO BE INSTALLED IN A RESTRICTED ACCESS AREA IN
ACCORDANCE WITH THE NEC OR THE AUTHORITY
HAVING JURISDICTION.
ON/OFF
DC Input Power Strip
2016_99