Dynojet 250: DynoWare EX+ Upgrade - Manual (Page 16)

DynoWare EX+ Upgrade Installation Guide
D Y N O W A R E E X + U P G R A D E
Installation
10
3 Attach the pickup card cable from the Breakout board to the pickup card.
4 Attach the appropriate end of the large PC data cable to the Breakout board and
secure with the plug screws (finger tight only).
5 Route the large PC data cable with the starter cable. Secure both cables back
under the lip of the front dyno cover using the cable clamps you removed earlier.
Figure 15: Attach and Route the Cables
cable clamp
starter cable
PC cable
front dyno cover
pickup card
cable
Breakout board
to PC
starter pendant