Dynojet 250: DynoWare EX+ Upgrade - Manual (Page 9)

I N S T A L L A T I O N G U I D E
Installation
Version 3 DynoWare EX+ Upgrade Installation Guide
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
The DynoWare EX+ system is comprised of four modules: the CPU Module, the
Dynamometer Input/Output Module, the RPM Module and the Atmospheric Sensing
Module. The upgrade requires a new pickup card and Breakout board (the interface
between the dyno and the new DynoWare EX+ hardware). This section will provide
you with the information necessary to install and connect the new components. If you
have an air brake you will need to make additional modifications; refer to “Air Brake
Modifications” on page 7 for more information.
Figure 2: DynoWare EX+ Modules
R EMOVING THE H OOD
1 Disconnect all power to the dyno.
2 Remove the four bolts securing the hood to the dyno.
3 Prop up the hood and disconnect all battery wires.
4 Remove the hood.
Figure 3: Remove the Hood
atmospheric
sensing module
RPM module
dynamometer
input/output module
CPU module