Bulkheads and covers, Installing the bulkheads – Dynojet 250iX: Upgrade Installation Guide User Manual
Page 23
M O D E L 2 0 0 I X / 2 5 0 I X U P G R A D E
Bulkheads and Covers
Version 1
Model 200iX/250iX Upgrade Installation Guide
1-15
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BULKHEADS AND COVERS
You will need the following parts:
• 21200022
Middle Bulkhead
• 21200024
Front Bulkhead
• 21600012
Toe Kick Bracket
• 36468100
Nut, 1/4-20, Nylock (5)
• 36561045
Screw, 1/4-20 x 5/8", PH, Torx (16)
• 61300007
Monitor Support Brace
• 76950053
Cable, Fan Power Extension
I
NSTALLING
THE
B
ULKHEADS
1
Place the monitor support brace on the five studs on the front bulkhead.
2
Secure the brace to the studs using five 1/4-20 nylock nuts.
3
Secure the front bulkhead to the dyno frame using four 1/4-20 x 5/8-inch button-
head screws.
4
Secure the middle bulkhead to the dyno frame using five 1/4-20 x 5/8-inch button-
head screws.
Figure 1-10: Securing the Front and Middle Bulkheads
middle bulkhead
front bulkhead
monitor support
brace