Dynojet 250iX: Upgrade Installation Guide - Manual (Page 52)

Model 200iX/250iX Upgrade Installation Guide
A P P E N D I X B
Ramp Installation
B-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RAMP INSTALLATION
Verify the dyno ramp is in place and secured to the dyno before beginning with the iX
upgrade ramp installation.
You will need the following parts:
• 21200029 Tie-Down Hook Plate
• 21200039 Ramp Top Cover
• 21200047 Ramp Panel
• 36561045 Screw, 1/4-20 x 5/8”, PH, Torx (8)
• 61300011 Folding Ramp Option
• DM150-020-005 Nut, Crush, 1/4-20 (8)
1 Remove the two existing 3/8-16 x 1.25-inch screws from the back of the iX drum
module.
2 Remove the two existing 1/4-20 x 5/8-inch screws from the top of the iX drum
module.
3 Slide the ramp up to the iX drum module.
4 Secure the ramp to the iX drum module using the screws removed earlier.
Figure B-1: Securing the Ramp to the iX Drum Module
existing screws from the back of
the iX drum module
existing screw from the top
of the iX drum module
dyno ramp
ramp