Dynojet 250iX: Upgrade Installation Guide - Manual (Page 9)

Model 200iX/250iX Upgrade Installation Guide
1-1
C
H A P T E R
1
M
ODEL
200
I
X/250
I
X U
PGRADE
Thank you for purchasing the 200iX/250iX upgrade for Dynojet’s Model 200i/250i
Motorcycle Dynamometer. This upgrade will allow you to run a kart, ATV, or trike on
your motorcycle dynamometer. Dynojet’s software and dynamometers will give you
the power to get the maximum performance out of vehicles you evaluate. Whether
you are new to the benefits of a chassis dynamometer or an experienced performance
leader, the repeatability and diagnostic tools of WinPEP 7 software and a Dynojet
dynamometer will give you the professional results you are looking for.
This document provides instructions for installing the 200iX/250iX upgrade to
Dynojet’s Model 200i/250i Motorcycle Dynamometer (dyno). This document will walk
you through the installation and basic dyno operation along with installing the
optional ramp. To ensure safety and accuracy in the procedures, perform the
procedures as they are described.
Document Part Number: 98200013
Version 1
Last Updated: 03-07-08
This section is divided into the following categories:
• Introduction, page 1-2
• Model 200iX/250iX Upgrade Specifications, page 1-3
• Dyno Preparation, page 1-6
• Drum Installation, page 1-10
• Bulkheads and Covers, page 1-15
• Trike Carriage Adapter Installation, page 1-20
• Tie-Down Installation, page 1-25
• Monitor Stand and Blower Installation, page 1-26
• Ground Hook Installation, page 1-28