Dynojet 224: CE Package User Manual
Page 16
CE Package Installation Guide for 224 Automotive Dynamometers
C E P A C K A G E
CE Door Switch
12
5
Insert the stripped wire into the butt connector and crimp.
Note: The butt connector is attached to the wire included with the CE door
switch.
6
Insert the ferrule, located on the same side as the butt connector, to the Breakout
board.
Note: The ferrule will connect to the Breakout board at the same terminal as the
removed brake wire.
7
If not already connected, attach the two ferrules, located on the other end of the
wire from the butt connector, to terminals 13 and 14 on the CE door switch.
8
Install the CE door switch on the top of the door jam so it will be activated when
the door to the dyno room or cell is opened.
Figure 12: Installing the CE Switch
butt connector
ferrule
CE switch wire
brake wire
connect ferrules
to CE switch
Breakout
board
CE switch