Dynojet 248: Maintenance Guide - Manual (Page 27)

A U T O D Y N O M A I N T E N A N C E
Model 424x All-Wheel Drive Dynos
Version 3 Maintenance Guide for Automotive Dynamometers
23
V ERIFYING THE SAAR B RAKE P RESSURE
1 Verify the SAAR brake pressure gauge reads 100psi (690kPa).
2 Using the knob, adjust the regulator until the correct pressure is achieved.
Figure 20: 424x Dyno—Check the SAAR Brake Pressure and Adjust the Regulator
AB096
use knob to adjust
regulator until correct
pressure is achieved
brake pressure
regulator
0
AB095
brake pressure gauge
should read 100psi
(690kPA)