Dynojet Data Link Module - OBDII - Manual (Page 17)

D A T A L I N K M O D U L E - O B D I I
Dynojet DLM-OBDII Dialog Box—Channels Tab
Version 4 Data Link Module-OBDII Installation and User Guide
13
E NABLING C HANNELS
Enabling is different than verifying channels. Any unsupported channels return to the
disabled state. You cannot enable unsupported channels. Having more than six
generic channels enabled at one time will slow down the incoming data rate. The
lower your data rate, the less precise your data will be.
1
Once a channel or channels have been selected, click Enable.
2 Click Close to exit the dialog box.
3 Click OK to exit the MakeRun Configuration dialog.
Enabled channels appear with *C_ in front of their abbreviated name in the list of
available WinPEP channels.
The Absolute Throttle Position channel shown below was verified. Since the PCM
has verified that it is able to provide data for this channel it shows as supported. It
has also been enabled for use in WinPEP. *C_TP is now in the list of available Data
Channels, refer to Figure 11.
Note: You cannot enable unsupported channels.
Figure 8: Channels Tab—Enabling Channels
channel
enabled
channel is
supported