Dynojet Data Link Module - OBDII User Manual
Page 9
D A T A L I N K M O D U L E - O B D I I
DJDLM-OBDII Setup
Version 4
Data Link Module-OBDII Installation and User Guide
5
C
ONFIGURING
THE
DJDLM-OBDII
1
Start the WinPEP software by double-clicking the desktop icon or by selecting
Start
!
All Programs
!
WinPEP 7
!
WinPEP 7.
When WinPEP starts, the Graph View shows by default.
2
Click the MakeRun button
on the toolbar or select Display
!
MakeRun
Screen from the menu choices.
3
Verify your computer is connected to the dyno electronics and the dyno
electronics is powered on. Refer to "Connecting the Dyno Electronics" in your
WinPEP 7 User Guide for more information.
4
Click the MakeRun Configuration button
.
Note: If You may have more than one DJDLM-OBDII connected to your network
at the same time, a window will pop up. Choose which device you wish to
connect to.
5
Click the Expansion Systems tab.
6
Select Dynojet DLM-OBDII.
7
Click the Configure button.
Figure 2: MakeRun Configuration—Expansion Systems
configure
button
expansion
systems tab
select Dynojet
DLM-OBDII