Dynojet Data Link Module - OBDII - Manual (Page 30)

Data Link Module-OBDII Installation and User Guide
A P P E N D I X A
Configuration
A-8
C ONFIGURING THE DJDLM-OBDII WITH A C ATEGORY 5 C ROSSOVER C ABLE
The category 5 crossover cable ships with the DJDLM-OBDII. This is the fastest data
transfer option available. No configuration is needed to the DJDLM-OBDII when
using the crossover cable; just plug and play.
1
Power the DJDLM-OBDII on in the car.
2 Attach the crossover cable to the Ethernet port on the DJDLM-OBDII.
3 Attach the crossover cable from the DJDLM-OBDII to the dynamometer PC’s
Ethernet port.
C ONFIGURING THE DJDLM-OBDII WITH A C ATEGORY 5 S TANDARD C ABLE
This configuration requires a standard category 5 patch cable and a network jack.
You must have a DHCP server configured on your network to run this option. If you
are not sure what a DHCP server is, contact Dynojet Technical Support or a local IT
professional.
1
In the Boot Options window, scroll down to Built-in Internet.
2 Select Client then Server from the Network Type drop down menu.
Once connected to your Ethernet network, the DHCP server will assign the
DJDLM-OBDII an IP address and it will be a network member. The DJDLM-OBDII
will then be visible through the network to WinPEP.
Figure A-10: Entering the Built-in Ethernet Parameters