Eden RS Combos - Manual (Page 10)

10
IMPORTANT NOTE: Before you plug in your unit for the first time,
please do the following things. First, turn the power switch to the OFF
position. Check the back of your unit for the correct voltage notation for
your county of operation.
Once you’ve ensured correct voltage, set the Master Volume control to
minimum (fully counter-clockwise). Set the tone controls to the center
position (12:00 or 0). Turn the Enhance and Edge controls to the minimum
position. Set the Input Gain control to the minimum (fully counter-
clockwise). Set the Compressor to the OFF position (push the switch IN).
This will set your amplifier flat and with the Compressor disengaged. Next,
plug in the power cord to the AC inlet on the back of the unit. Use only a
safe grounded receptacle for proper operation at the correct voltage for your
country.
Double check to make certain your amplifier is set for the correct voltage in
your country. Double check that all connections and switches are correct for
your chosen mode of operation.
Turn On – Once you’ve completed the steps above, you can plug in your
bass and turn on the unit (plug it in first, ok?) and let’s get started. We
recommend turning your system on with the Master Volume control set to
its minimum position. This will prevent any unexpected signal from being
sent to your speakers.
Setting Your Level – Remember, begin with the Input Gain, Enhance,
Compressor and Master Volume completely OFF – fully counter-clockwise.
All EQ should be set flat, that is, at 12:00 – straight up.